NewsInformation Center
G282 Universal Fabric Wear Tester Operation Steps
2025/01/06
Share:
G282 Universal Fabric Wear Tester is equipped with a flat wear test head (inflatable membrane wear test method) and a curved wear test head, as well as the required weights and sandpaper. It can perform flat wear, curved wear, edge wear, folded edge wear, anti-frost, hemming, and napping wear tests. The test sample can be dry or immersed in water, oil, or other liquids. It can be used for woven fabrics, knitted fabrics, coated fabrics, napped fabrics, socks, felt, non-woven fabrics, deep fabrics, yarn, ropes, plastic films, rubber, leather, paper, and many other materials.
As a modern technology enterprise integrating R&D, manufacturing, sales, training, and services, Standard International Group (HK) Limited is committed to delivering more testing instruments to the market, providing testing instruments for textiles, leather, combustion, automotive interior and exterior trims, material environmental climate aging, etc., and non-standard customization is also acceptable. Targeted tests can be carried out according to customer requirements before purchase to ensure that the purchased instruments are applicable.
As a modern technology enterprise integrating R&D, manufacturing, sales, training, and services, Standard International Group (HK) Limited is committed to delivering more testing instruments to the market, providing testing instruments for textiles, leather, combustion, automotive interior and exterior trims, material environmental climate aging, etc., and non-standard customization is also acceptable. Targeted tests can be carried out according to customer requirements before purchase to ensure that the purchased instruments are applicable.
Applicable standards:
ASTM D3514 D3885 D3886, AATCC 119/120, FORD EFB 15J2/BN 112-01, etc.
Main parameters:
1. Clamp ring inner diameter: 94mm;
2. Locking ring height: ≤9.5mm;
3. Speed: 120±15/min;
4. Stroke: 25mm;
5. Air pressure: 62kPa (9psi).
Operation steps:
First: prepare the accessories and test samples;
Use the sample wrench to disassemble the clamp;
Install the tympanum and sample in the clamp;
Tighten and fix the clamp;
Fix the abrasive in the upper clamp;
Install the weight;
Turn on the instrument and enter the operation interface;
Set the number of turns and adjust the air pressure;
The sample expands to a certain height as the air pressure increases;
Lower the upper clamp to make abrasive contact with the sample;
Press the start button;
The abrasive and the sample continue to rub;
The sample is worn and stops automatically;
Turn off the instrument and end the test. After the instrument test is over, remove the sample for analysis and comparison to evaluate the wear resistance of the material surface.
Previous: BS5852 Mattress and Sofa Anti-Ignition Tester Operation Steps
N e x t : Paper and cardboard crease stiffness tester experimental parameters
